Dishwasher - How to replace pressure sensor kit (2)

Riešenie

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety glovesif you perform maintenance or repair work involving belts.

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE PRESSURE SENSOR KIT (V2)

1. Remove the filter and it’s housing the use a small syringe and some old towels to drain the water in the sump.

2. Carefully tilt the dishwasher back and unhook the plinth at the top on each side

3. Unhook the front feet and pull the plinth towards you to remove

4. Unscrew the PH2 screw for the side panel and then unscrew the three PH2 screws holding the front feet on for both sides.

5. Remove the two front legs and the bottom panel by pulling both towards you to release

6. Carefully pull the base down to expose under the sump.

7. Unplug the wiring connector from the pressure sensor. Be careful not to damage the wiring connector.

8. Using a small flat blade screwdriver unhook the clip for the pressure switch on the sump.

9. Pull the pressure switch away from the sump to remove.

10. NOTE: Prior to reinstalling, it is recommended to clean the sump and air chamber using a cable tie.

11. When assembling, repeat steps in reverse order